Guide de formation plus récente de Cisco 100-101

Le test Cisco 100-101 est test certification très répandu dans l'industrie IT. Vous pourriez à améliorer votre niveau de vie, l'état dans l'industrie IT, etc. C'est aussi un test très rentable, mais très difficile à réussir.

Maintenant, beaucoup de professionnels IT prennent un même point de vue que le test Cisco 100-101 est le tremplin à surmonter la pointe de l'Industrie IT. Beaucoup de professionnels IT mettent les yeux au test Certification Cisco 100-101.

La Q&A lancée par Pass4Test est bien poupulaire. Pass4Test peut non seulement vous permettre à appendre les connaissances professionnelles, et aussi les expériences importantes résumées par les spécialistes dans l'Industrie IT. Pass4Test est un bon fournisseur qui peut répondre une grande demande des candidats. Avec l'aide de Pass4Test, vous aurez la confiance pour réussir le test. Vous n'aurez pas aucune raison à refuser le Pass4Test.

Code d'Examen: 100-101

Nom d'Examen: Cisco (CCNA Interconnecting Cisco Networking Devices 1 (ICND1))

Questions et réponses: 102 Q&As

Est-que vous s'inquiétez encore à passer le test Certification 100-101 qui demande beaucoup d'efforts? Est-que vous travaillez nuit et jour juste pour préparer le test de Cisco 100-101? Si vous voulez réussir le test Cisco 100-101 plus facilement? N'hésitez plus à nous choisir. Pass4Test vous aidera à réaliser votre rêve.

Le test de Certification Cisco 100-101 devient de plus en plus chaud dans l'Industrie IT. En fait, ce test demande beaucoup de travaux pour passer. Généralement, les gens doivent travailler très dur pour réussir.

100-101 Démo gratuit à télécharger: http://www.pass4test.fr/100-101.html

NO.1 Which OSI layer header contains the address of a destination host that is on another network?
A. application
B. session
C. transport
D. network
E. data link
F. physical
Answer: D

Cisco   100-101   100-101   100-101   100-101
Explanation:
Only network address contains this information. To transmit the packets the sender uses network
address and datalink address. But the layer 2 address represents just the address of the next hop
device on the way to the sender. It is changed on each hop. Network address remains the same.

NO.2 Refer to the exhibit.
If the hubs in the graphic were replaced by switches, what would be virtually eliminated?
A. broadcast domains
B. repeater domains
C. Ethernet collisions
D. signal amplification
E. Ethernet broadcasts
Answer: C

Cisco examen   100-101 examen   certification 100-101   certification 100-101
Explanation:
Modern wired networks use a network switch to eliminate collisions. By connecting each device
directly to a port on the switch, either each port on a switch becomes its own collision domain (in
the case of half duplex links) or the possibility of collisions is eliminated entirely in the case of full
duplex links.

NO.3 Which layer of the TCP/IP stack combines the OSI model physical and data link layers?
A. Internet layer
B. transport layer
C. application layer
D. network access layer
Answer: D

certification Cisco   certification 100-101   100-101   certification 100-101
Explanation:
The Internet Protocol Suite, TCP/IP , is a suite of protocols used for communication over the internet.
The TCP/IP model was created after the OSI 7 layer model for two major reasons. First, the
foundation of the Internet was built using the TCP/IP suite and through the spread of the World
Wide Web and Internet, TCP/IP has been preferred. Second, a project researched by the
Department of Defense (DOD) consisted of creating the TCP/IP protocols. The DOD's goal was to
bring international standards which could not be met by the OSI model. Since the DOD was the
largest software consumer and they preferred the TCP/IP suite, most vendors used this model rather
then the OSI. Below is a side by side comparison of the TCP/IP and OSI models.
TCP/IP Model VS. OSI Model Application Layer 7 Application Layer 6 Presentation Layer 5 Session
Transport Layer 4 Transport Internet Layer 3 Network Network Access Layer 2 Data Link Layer 1
Physical

NO.4 Which three statements are true about the operation of a full-duplex Ethernet network?
(Choose three.)
A. There are no collisions in full-duplex mode.
B. A dedicated switch port is required for each full-duplex node.
C. Ethernet hub ports are preconfigured for full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network
media before transmitting.
E. The host network card and the switch port must be capable of operating in full-duplex mode.
Answer: A,B,E

Cisco examen   100-101   certification 100-101   100-101

NO.5 Which protocol uses a connection-oriented service to deliver files between end systems?
A. TFTP
B. DNS
C. FTP
D. SNMP
E. RIP
Answer: C

certification Cisco   100-101   certification 100-101
Explanation:
FTP is an acronym for File Transfer Protocol. As the name suggests, FTP is used to transfer files
between computers on a network. You can use FTP to exchange files between computer accounts,
transfer files between an account and a desktop computer, or access online software archives

NO.6 Refer to the exhibit.
If host A sends an IP packet to host B, what will the source physical address be in the frame when it
reaches host B?
A. 10.168.10.99
B. 10.168.11.88
C. A1:A1:A1:A1:A1:A1
D. B2:B2:B2:B2:B2:B2
E. C3:C3:C3:C3:C3:C3
F. D4:D4:D4:D4:D4:D4
Answer: E

Cisco   100-101 examen   certification 100-101   100-101 examen
Explanation:
When packets transfer from one host to another across a routed segment, the source IP address
always remains the same source IP address, and the source physical (MAC) address will be the
existing router's interface address. Similarly, the destination IP address always remains the same
and the destination physical (MAC) address is the destination router's interface address.

NO.7 Refer to the exhibit.
HostX is transferring a file to the FTP server. Point A represents the frame as it goes toward the
Toronto router. What will the Layer 2 destination address be at this point?
A. abcd.1123.0045
B. 192.168.7.17
C. aabb.5555.2222
D. 192.168.1.1
E. abcd.2246.0035
Answer: E

certification Cisco   100-101   100-101 examen   100-101
Explanation:
For packets destined to a host on another IP network, the destination MAC address will be the LAN
interface of the router. Since the FTP server lies on a different network, the host will know to send
the frame to its default gateway, which is Toronto.

NO.8 Refer to the exhibit.
The host in Kiev sends a request for an HTML document to the server in Minsk. What will be the
source IP address of the packet as it leaves the Kiev router?
A. 10.1.0.1
B. 10.1.0.5
C. 10.1.0.6
D. 10.1.0.14
E. 10.1.1.16
F. 10.1.2.8
Answer: E

Cisco examen   100-101 examen   100-101
Explanation:
Although the source and destination MAC address will change as a packet traverses a network, the
source and destination IP address will not unless network address translation (NAT) is being done,
which is not the case here.

Choisir le produit fait avec tous efforts des experts de Pass4Test vous permet à réussir 100% le test Certification IT. Le produit de Pass4Test est bien certifié par les spécialistes dans l'Industrie IT. La haute qualité du produit Pass4Test ne vous demande que 20 heures pour préparer, et vous allez réussir le test Cisco 100-101 à la première fois. Vous ne refuserez jamais pour le choix de Pass4Test, parce qu'il symbole le succès.